**************************************************************************************
	USB-RS232 module, EPT config overview
**************************************************************************************
	Device: 	PCA100294-1
	Description: 	USB-RS232 module, 4 ports.

--------------------------------------------------------------------------------------

Basic steps:

- Use MProg 3.5 Tool to load ept config. 
	o To avoid conflicts this should be done on a unit without any other FTDI devices connected.
	o If several FTDI devices are connected, the first device will use the serial from list below. 
	  The next devices will use last serial value + 1.

- Serial will be set according to the list below, when loading corresponding ept config file.
	o Other then different serial the RS232 ept config settings are identical.
	
- New images will be setup with serial linked to the COM specified in list below.


**************************************************************************************
  	  Serial and COM assignment for models based on Q87 chipset
**************************************************************************************

Internal (PCA100294-1)
	Internal #1:	RS232-V1-INT-BANK1.EPT	SN: 23201A-D	COM: 21-24
	Internal #2:	RS232-V1-INT-BANK2.EPT	SN: 23202A-D	COM: 25-28

External (HT 00263 OPT-A1)	
	External #1:	RS232-V1-EXT-BANK1.EPT	SN: 23211A-D	COM: 37-40
	External #2:	RS232-V1-EXT-BANK2.EPT	SN: 23212A-D	COM: 73-76
	External #3:	RS232-V1-EXT-BANK3.EPT	SN: 23213A-D	COM: 77-80
	External #4:	RS232-V1-EXT-BANK4.EPT	SN: 23214A-D	COM: 81-84

**************************************************************************************


PS: Factory image for QM57 models is only locked to two RS422/485 modules.
RS232 will only be locked for custom models where this module is included.

